Acrylic Display Case, Plastic display stands, Display Case so Styles.
Traditional Display Case
Our display cases with a wooden base have a wooden trim around the outside of the base. This is available in a choice of three colours, Light Oak, Mahogany and Black Ash. This wooden trim provides a 5mm high lip around the outside which is what stops the display cover from being pushed, or sliding off. The flat display area is covered in a soft baize, which is supplied in either black, green, moss green, cream, blue or red. This gives a choice of eighteen different colour combinations, which should be enough to suit your displayed item and the room surroundings.
This style of base has the widest range of display case sizes when ordered as a custom size, and the widest choice of stock sizes. It is available with a 3mm thick acrylic cover or a 5mm thick acrylic cover, depending on the size of the display case. All of the stock size display cases in this style are available as a cover only, without a base.
Modern Display Case This range of display cases is available with either black gloss acrylic bases which reflect the displayed item in them, or with clear bases, for a very minimalistic effect for your display. The bases have two pieces of 5mm thick Perspex, held together by machined stainless steel posts. The lower base has plastic feet on the bottom to raise it slightly off your surface to prevent damage to your surface or the bottom of the display base. This is larger than the size of the display cover, so the cover will sit on top of this piece. The upper part of the base is slightly smaller, so it fit inside the display cover, thereby stopping the cover from sliding off the base. This makes the base about 20mm thick, but all size on this website allow for that, so if you order a display case 200mm high, you will receive a display case with a inside display height of 200mm.
As with all of our display cases, we have a wide range of standard sizes, as well as it being available made to order. Please nte that this style cannot be made as large as the traditional wooden base display cases above.
Acrylic Base Display Case
This style has a simple flat base made from 5mm thick acrylic. The stock sizes for this style are exactly the same as for the traditional wooden base style, with the exception that the height on these is 3mm shorter, this is because they use the same covers but the flat acrylic base has a rebate around the outside edge which is 2mm deep, this enables it to fit the cover and provide a lip to stop the cover from sliding off. These display boxes are less aesthetically pleasing than the wooden base or the modern design but can be used upside down with the base used as a lid. This is why the four rubber feet are supplied loose, so you can decide which way to use it, then put the feet on the bottom yourself. This style is also available made to any size, but please note that when you order one of these made to custom sizes that the interior height will be 2mm less, due to the design of the base.
Display Cover Only
We can also supply our display cases as a cover only, so you can fit them to your own base or use them without a display base/plinth. Display covers are available from stock sizes or as a custom size. To order a custom sized display cover just go to the custom display case section, or browse our display covers only section.